OSP-100

Salem · Postby **Salem** » Sat Oct 24, 2015 1:25 am

I have just replaced the 24 volt power supply board as a result of the disalarm light having been turned on with the monitor not working. The monitor comes on for a minute once in while before going back off. Does any one have any suggestions please?

Pendragon · Postby **Pendragon** » Fri Oct 30, 2015 4:51 am

Hi Salem, try performing the reset process, that is if you have the manual.

Ramses · Postby **Ramses** » Fri Oct 30, 2015 4:53 am

What type of OSP-100 are you using?

Salem · Postby **Salem** » Fri Oct 30, 2015 5:21 am

I am using the Okuma Captain L370M-P100. I do not have the manual either.

Pendragon · Postby **Pendragon** » Fri Oct 30, 2015 5:33 am

Go to http://www.shamrockmachinery.com/manual ... folder.htm
This is where you can get the manual.

Salem · Postby **Salem** » Fri Oct 30, 2015 5:43 am

Thanks a lot Mr. Pendragon. I checked the manual and i have finished the reset process but there is no improvement..

Chris · Postby **Chris** » Fri Oct 30, 2015 5:57 am

Perhaps you didn't do the replacement in the right manner.check it again and if you are not confident that you can do it look for help from somebody who knows how to play with the connections

Amateur CNC forum for hobby cnc users and small business

OSP-100

OSP-100

Re: OSP-100

Re: OSP-100

Re: OSP-100

Re: OSP-100

Re: OSP-100

Re: OSP-100

Who is online