Page 1 of 1

Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:04 pm
by Dhafi
I have been looking for a t-slot bit and surfacing bit for 2 months now but have not been successful. Spoil board surface cutters in most sales sites go at a minimum of $175. What other sites in Europe or US can I find these items? They should be reasonably priced though.

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:06 pm
by ChxurryX
Have you tried Aliexpress and Amazon? You can't miss them there.

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:08 pm
by May33
Why look for both when T-slot can do surfacing?

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:13 pm
by Dhafi
ChxurryX wrote:Have you tried Aliexpress and Amazon? You can't miss them there.
I have tried amazon and Aliexpress but could not find them there.

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:25 pm
by Akelangegia
Go to eBay

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:27 pm
by Noob
If you can be patient a bit, I have ordered some Chinese “bottom cleaning” 30 mm bits. which will be araiving in a fortnight.

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:28 pm
by Dhafi
May33 wrote:Why look for both when T-slot can do surfacing?
I know that the t-slot bit can be used for surfacing but I just need both.

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:30 pm
by Dhafi
Noob wrote:If you can be patient a bit, I have ordered some Chinese “bottom cleaning” 30 mm bits. which will be araiving in a fortnight.
A fortnight is way too far. But how much are these Chinese Bottom Cleaning bits?

Re: Looking for T-slot bit and Surfacing bit

Posted: Sat Apr 23, 2016 7:31 pm
by Dhafi
Noob wrote:If you can be patient a bit, I have ordered some Chinese “bottom cleaning” 30 mm bits. which will be araiving in a fortnight.
A fortnight is way too far. But how much are these Chinese Bottom Cleaning bits?

Re: Looking for T-slot bit and Surfacing bit

Posted: Sun Apr 24, 2016 5:10 am
by Noob
They go for only $4 inclusive of postage