machining of plastics and ally- whish spindle?

[Looker]

Hi guys,
I am planing to machine plastics and ally using Proxxon die-cast Alluminium X-Y and i am looking at the spindles. I would appreciate an advice from someone who has experience on the Proxxon BFW 40/E spindle(900- 6000rpm). would it be better if i go for Kress spindles? if yes, which one?

[ChxurryX]

There are two spindles that can be good for your work. The BFW and Kress. I would however advise you to go for Kress due to its quality results

[Slania77]

Go for Kress 1050. this one can be used for daily production.
Power input 1050 Watt / 240V
No-load speed / Idling 10000 - 32000 r.p.m.
Available Clamping jaw / Collets: 1 to 8mm
Mounting Ø 43 mm
Weight 2.4 kg

Materials: Engraving of steels
Machining: All soft alloys ets ie. brass, bronze Ally
Wood: All
Plastics: All
I hope this will help you...

[Alligatore]

How much would i need in terms of money inorder to get that?

[josiahN]

Feel free to try one this. It is from a disassembled disk

spindl.PNG (64.82 KiB) Viewed 1229 times

[Looker]

Thanks for your suggestions guys. I acquired Kress 1050 and it does the machining so well. Thanks once again