THC floating Head

[soverinHo]

I am using a Mk1 controller from buildyourowncnc.com. How do should i set up the G-code such that it follows the correct procedure and Zeros the Z height automatically before cutting each new part when a program is running?

[nellyJ]

I do had the same problem, but some how i got the information i wanted on this link http://www.instructables.com/id/Machini ... ng-G-Code/
I hope it helps you

[peterKR]

Thanks a lot for sharing NellyJ. Do you know somewhere i can get the classes?