Hey! Can anyone help me to get V-Groove cutter that I will use in making 90 degrees miter joins in 16mm plywood. The Wealden cutter part No.T112 that...
Last post
Thanks. I am going to order a few of those. I am optimistic that it will work pretty well for my 9mm stock.
Hi everyone,
I am currently renovating an old Halifax 10 inch lathe that has been lying idle for a number of years. On the left hand end of the main...
Last post
Thanks for the information guys. I tried all the options. I have checked on the amount of thread remaining and yes that was where the problem lied. I...
Hi everyone
I am new to the CNC world. Just a week ago I acquired a Boxford 240 TCL with of course came with Boxford software. I however have a...
Last post
Welcome Keller. I would say that's a good move. welcome to the CNC world once more and wish luck in your ventures.
Amateur CNC Forum is the place to...
Tell me the right kind of CNC Router Bit that should be used im order to cut a stack of paper ie a book? I need a hollow book out so that i may make...
Last post
Irregardless of what opinion people may have routers remain the wrong tool for cutting the paper.
Hello all, i require some with the centurion6. I do own an electric cabinet that has been equipped with the machine though i also have one wire that...
Last post
The wiring problem should not be an issue if you can still contact the shop where you got it from. I would think that would be your first option but...
We have an Oxy-Flame Cutter that came with the shop. How much will it sell for at e-Bay or elsewhere?
Last post
Well, the price ranges on e-bay will vary depending on its condition. Just post its picture here so that i may be able to approximate the figure for...
Users browsing this forum: No registered users and 1 guest
Forum permissions
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum